This polishing kit is for use with Ferrous Metals and contains the following:

• Aggressively removes paint, rust and coatings
• Load resistant material resists clogging for consistent cutting action
• Smear resistant properties avoid extra cleaning of the work surface

• High power induction motor suitable for workshop use.
  
• Fitted with aluminous oxide grinding wheels and suitable for general sharpening and grinding applications.
  
• Equipped with fully CE approved safety guards and wheel location flanges to meet current EU abrasive wheel regulations.
  

• Induction motor drive suitable for general use.
  
• Fitted with stone guards, adjustable eyeshields and spark arrestors.
  
• Fully CE approved electrics for operator safety.
  

• Faster alternative to the traditional wooden back wire brush
• Ideal for removing paint, factory primer and rust
• Wire bristles are encapsulated in pressure moulded epoxy resin, which prevents the bristles from splintering or flexing off the job and will get right down to bare metal in a single pass.

This Wire End Brush is suitable for cleaning paint or deburring moulds or castings in hard-to-reach areas such as cylinders. The brush has crimped steel wire and is designed for light to medium-duty applications.

Suitable for use in industrial power tools at higher speeds.

Maximum speed: 5,500/min.

Discs designed for removing decals, striping tape and double sidefoam tapes.